中文
EnglishHow to carry out partition construction of fireproof glass
Fireproof glass is mainly used to control the extension of fire or isolate smoke. It is a method type fireproof material. Its fireproof function is evaluated by its fireproof function. It is a special glass processed and treated by special technology, which can adhere to its integrity and heat insulation in regular fire resistance experiments. The original piece of fireproof glass can be float flat glass, tempered glass, composite fireproof glass, or single piece of fireproof glass.
Fabrication and installation procedures of fireproof glass partition wall: Measurement and setting out - material ordering - Fabrication and installation of upper and lower steel parts - equipment glass - gluing - cleaning.
1) measurement and setting out: measure and set out according to the standards of planning drawings, and measure the elevation of base course surface, which is in the glass wall
Central axis, upper and lower parts, position line of closing stainless steel groove;
2. Glass trough equipment on the lower side and upper part of embedded iron parts: steel part at the bottom of the trough according to the standard equipment in the planning drawings
Parts, fixed with expansion bolts, and then steel glass grooves on the upper and side of the equipment. Straighten and fix. The bottom tape in the equipment groove and the non stainless steel parts shall be painted with antirust paint;
3. Positioning of glass block equipment: all tempered flat glass shall be customized by the manufacturer and transported to the construction site.
Clean the glass trough and glass block, place the glass block in the equipment trough with glass equipment machine or mail suction cup, plug and fix it with plastic block after leveling and verticality, level all equipment of the same glass wall, and start glue injection after verticality;
4. Glue injection: first clean the upper and lower parts, the stainless steel glass groove on the side and the glue injection place of the glass seam, and then stick the glass and stainless steel plate on both sides of the glue injection with white tape, leaving the glue injection seam position. The national rules require glue injection. The same seam is filled and scraped at one time without stopping. (Note: a. the glue can be injected only when the glue injection seam is monotonous and should not be wet; B. the glue injected in the upper and lower stainless steel grooves is structural silica gel, and the glue injected in the gap between glass blocks is transparent glass glue).
5) cleaning and hygiene: clean the glass block with glass cleaner. (do not wash with acid solution)
From fireproof glass http://www.www.hzjunyuekj.cn/
-
05-04
What are the problems of composite fireproof glass in fire fighting
Some supervisors mistakenly think that the door made of fireproof glass is the fireproof door, the partition made of fireproof glass is the fireproof glass partition, and the window made of fireproof
-
04-12
Fireproof glass door: how to ensure that the fireproof door can play a role in critical times
How to ensure that the fire door can give full play to its ideal effect in critical time?1. Select appropriate typesAccording to the relevant specific introduction of fire doors, we can know that at t
-
02-17
Where is the fireproof glass generally installed
(1) the fireproof glass is generally installed on something. It may not be checked from time to time before installation. If the warpage, unsightness and glass hazards of the window edge and window ar
-
10-30
How to distinguish the quality of single fireproof glass?
1. Equipment conditions:No matter how to make a single piece of fireproof glass, it can't be done without some equipment, so if the manufacturer doesn't have the equipment, it can't mak